Energy Star Recommendations – Your home has humidity problems, excessive dust, or rooms that never seem to get comfortable

Leaky or poorly insulated ductwork might be the cause. Seal Your Heating and Cooling Ducts! Ducts are used to distribute conditioned air throughout houses with forced-air heating and cooling systems. In typical houses, about 20 percent of the air that moves through the duct system is lost due to leaks, holes, and poorly connected ducts. The result is an inefficient HVAC system, high utility bills, and difficulty keeping the house comfortable, no matter how the thermostat is set.

Energy Star Recommends These Simple Steps to Improving Duct Performance:

  • Because ducts are often concealed in walls, ceilings, attics, and basements, repairing them can be difficult. But there are things that you can do to improve duct performance in your house.
  • Start by sealing leaks using mastic sealant or metal (foil) tape and insulating all the ducts that you can access such as those in the attic, crawlspace, basement, or garage. Never use ‘duct tape,’ as it is not long-lasting.
  • Also make sure that the connections at vents and registers are well-sealed where they meet the floors, walls, and ceiling. These are common locations to find leaks and disconnected ductwork.

Energy Star Recommendations  – What a Qualified Contractor Should Look For

Many homeowners choose to hire a professional contractor for duct improvement projects. Most heating and cooling contractors also repair ductwork. Look for a contractor who will:

  • Inspect the whole duct system.
  • Repair or replace damaged, including the attic, basement, disconnected, or undersized and crawlspace (if you have ducts and straighten out flexible these). Ducts that are tangled or crushed.
  • Seal gaps behind registers and grills where the duct meets the floor, wall, or ceiling.
  • Insulate ducts in unconditioned areas with insulation that carries an R-value of 6 or higher.
  • Include a new filter as part of any duct system improvement.
  • Use diagnostic tools to evaluate air flow after repairs are completed.
  • Ensure there is no back drafting of gas or oil-burning appliances, and conduct a combustion safety test after ducts are sealed.

Whether you want to schedule an annual equipment maintenance check-up or you’ve decided that you need to purchase and install new heating or cooling equipment, you will need to hire a contractor.